ELIMINATION OF FREQUENT DIE CHANGES

COMPARISON BETWEEN V DIE AND WING BEND
2V(1V) DIE			WING BEND
	2V DIE ALTHOUGH TWO(2) KINDS OF "V" WIDTH IS AVAILABLE, FREQUENT DIE CHANGES ARE NECESSARY IN CASE OF BENDING DIFFERENT THICKNESS.	�@�@�@�@�@		��REDUCTION OF TOOL COST AND EASY TOOL MANAGEMENT ��ONCE ALIGNED,DIE CHANGE IS NOT NECESSARY. WING BEND LOWERS DIE CHANGE SUBSTANTIALLY AND PROVIDES THE HIGH PRODUCTIVITY. WB120: (BENDING THICKNESS:0.3T-1.2T) WB230: (BENDING THICKNESS:0.3T-2.3T) WB650: (BENDING THICKNESS:0.5T-6.5T) ��YOU MAY NEED TWO WING BEND DIES DEPENDING ON BENDING PRODUCTS.
	ALIGNED 2V DIE GETTING ALIGNMENT IS NOT NECESSARY EVEN AFTER CHANGING "V" WIDTH, HOWEVER, DIE CHANGES ARE STILL NECESSARY FOR BENDING DIFFERENT THICKNESS.
	1V DIE SET-UP TIME FOR DIE CHANGE IS SHORTER THAN THAT OF 2V AND ALIGNED 2V DIES. HOWEVER, DIE CHANGES ARE STILL NECESSARY FOR BENDING DIFFERENT THICKNESS.

COMPARISON OF DIE SET-UP TIME
FIRST SET-UP TIME
2V DIE 1V DIE WING BEND (WB230)	BENDLING LENNGTH:2M	IT TAKES ABOUT 2.5 TIMES TO SET UP WING BEND DIE AS COMPARED WITH THE CONVENTIONAL DIES.
2ND & AFTER SET-UP TIME
2V DIE 1V DIE WING BEND (WB230)	BENDING LENGTH:2M	USING WING BEND, SET-UP TIME GOES DOWN DRAMATICALLY AND YOU GET THE FOLLOWING ADVANTAGES. 1)THE OPERATORS' JOBS ARE REDUCED DUE TO NO DIE SET-UP. �@��THE OPERATORS NEED NOT LOAD AND UNLOAD DIES AND ALIGNMENT. �@��THE TIME FOR FINDING AND SELECTING DIES IS REDUCED. �@��THE CARELESS MISTAKE FOR SELECTING DIES IS NOTMADE. 2)THE OPERATORS CAN EASILY MANAGE TOOLS. 3)WING BEND CONTRIBUTES HIGH PRODUCTIVITY AND GREATER PROFIT.

|TOP PAGE|